User manual

Configuration 15 (30)
Wireless settings - Client
Fig. 16 Wireless settings – Client
Wireless Settings - Client
Label Description
Peer AP SSID Enter the SSID of the WLAN AP to connect to
Peer AP BSSID Enter the BSSID (MAC address) of the WLAN AP (if required)
Site Survey Click to scan for available wireless networks
WDS-Slave Mode When enabled, the unit will act as a WDS slave on this network.
Security options See Wireless settings – AP, p. 14
Wireless settings - Bridge
Fig. 17 Wireless settings – Bridge
Wireless settings - Bridge
Label Description
WDS Mode WDS can be set to operate in Bridge Mode or Repeater Mode. See below for an
explanation of these modes.
Peer MAC Address Enter the MAC address of each access point and check the Enable box.
SSID (Repeater Mode) Enter an SSID (network name) for the network. All devices must be configured with
the same SSID.
Channel Enter the WLAN channel to use for the network. All devices must be configured to
use this channel.
Security options See Wireless settings – AP, p. 14
Anybus
®
WLAN Access Point IP67 User Manual SCM-1202-094-EN 1.0