Instructions
Table Of Contents
- 1 Preface
- 2 Description
- 3 Installation
- 4 Configuration
- 4.1 General
- 4.2 Web Interface
- 4.2.1 System Overview
- 4.2.2 Easy Config
- 4.2.3 Network Settings
- 4.2.4 WLAN Settings - Client
- 4.2.5 WLAN Settings - Access Point
- 4.2.6 Bluetooth Settings – General
- 4.2.7 Bluetooth Settings – PANU Mode
- 4.2.8 Bluetooth Settings – NAP Mode
- 4.2.9 Bluetooth LE Settings
- 4.2.10 Firmware Update
- 4.2.11 AT Commands
- 4.2.12 System Settings
- 4.3 Factory Restore
- A Configuration Examples
- B Wireless Technology Basics
- C Technical Data
Installation 7 (40)
3 Installation
3.1 Safety
Caution
This equipment emits RF energy in the ISM (Industrial, Scientific, Medical) band. Make
sure that all medical devices used in proximity to this device meet appropriate
susceptibility specifications for this type of RF energy.
This product is recommended for use in both industrial and domestic environments. For
industrial environments it is mandatory to use the functional earth connection to comply
with immunity requirements. For domestic environments the functional earth must be
used if a shielded Ethernet cable is used, in order to meet emission requirements.
This product contains parts that can be damaged by electrostatic discharge (ESD). Use
ESD prevention measures to avoid damage.
See also additional safety instructions in the included compliance information.
3.2 General Information
Make sure that you have all the necessary information about the capabilities and restrictions of
your local network environment before installation.
The characteristics of the internal antenna should be considered when choosing the placement
and orientation of the unit.
For optimal reception, wireless devices require a zone between them clear of objects that could
otherwise obstruct or reflect the signal. A minimum distance of 50 cm between the devices
should also be observed to avoid interference.
See also Wireless Technology Basics, p. 36.
Anybus
®
Wireless Bolt
™
User Manual
SCM-1202-007 2.6 en-US