Instructions
Table Of Contents
- 1 Preface
- 2 Description
- 3 Installation
- 4 Configuration
- 4.1 General
- 4.2 Web Interface
- 4.2.1 System Overview
- 4.2.2 Easy Config
- 4.2.3 Network Settings
- 4.2.4 WLAN Settings - Client
- 4.2.5 WLAN Settings - Access Point
- 4.2.6 Bluetooth Settings – General
- 4.2.7 Bluetooth Settings – PANU Mode
- 4.2.8 Bluetooth Settings – NAP Mode
- 4.2.9 Bluetooth LE Settings
- 4.2.10 Firmware Update
- 4.2.11 AT Commands
- 4.2.12 System Settings
- 4.3 Factory Restore
- A Configuration Examples
- B Wireless Technology Basics
- C Technical Data
Configuration 28 (40)
4.3 Factory Restore
Any one of these actions will restore the factory default settings:
• Clicking on Factory Restore on the System Settings page
• Executing Easy Config Mode 2
• Issuing the AT command AT&F and then restarting the unit
• Holding RESET pressed for >10 seconds and then releasing it
• Applying voltage to the digital input for >10 seconds
Default Network Settings
IP Assignment Static
IP Address
192.168.0.99
Subnet Mask
255.255.255.0
Default Gateway
192.168.0.99
Internal DHCP Server Disabled
Default WLAN Settings
Operating Mode Client
Channel Bands
2.4 GHz & 5 GHz
Authentication Mode
WPA/WPA2–PSK
Channel
Auto
Bridge Mode Layer 3 IP forward
Default Bluetooth Settings
Operating Mode PANU (Client)
Local Name [generated from MAC address]
Connectable
No
Discoverable
No
Security Mode Just works
Bluetooth LE Disabled
Anybus
®
Wireless Bolt
™
User Manual
SCM-1202-007 2.6 en-US