Instructions

AT Commands 55 (84)

3.8.17 AT*AMPSM PROFIsafe Mode

Enable PROFIsafe Mode, in PROFIsafe mode it's only possible to read configuration. To write

configuration again, it's necessary to reset to factory defaults with the physical button.

AT*AMPSM=

Enable/Disable PROFIsafe mode.

Syntax:

AT*AMPSM=<profisafe_mode>,<apply_now>,<store>

Input Parameters:

Name

Type Description

profisafe_mode

Integer

Set state of PROFIsafe mode.

0: Disable.

1: Enable.

apply_now Boolean 0: Apply changes after reboot.

1: Apply changes immediately.

store

Boolean If store is 1 the new value is stored permanently.

Example:

Input: AT*AMPSM=1,1,1 Output: *AMPSM:OK

AT*AMPSM?

Read state of PROFIsafe mode.

Syntax:

AT*AMPSM?

Example:

Input: AT*AMPSM? Output: *AMPSM:<profisafe_mode>

3.8.18 AT*AMIC Interface configuration

AT*AMIC?

Command to read back interface configuration bit mask

Syntax:

AT*AMIC?

Example:

AT*AMIC? *AMIC:<iface_config>

Wireless Bolt

™

/ Wireless Bridge II

™

Reference Guide

SCM-1202-004 1.7 en-US