Instructions

AT Commands 54 (84)
3.8.15 AT*AMLCR Layer 2 Configuration Receiver
Configure AT over layer 2 (Ethernet)
AT*AMLCR=
Set AT over layer 2 configuration
Syntax:
AT*AMLCR=<eth_type>,<enable>,<store>
Input Parameters:
Name
Type Description
eth_type
Integer
16 bit Ethernet type that should be used for AT commands
enable Boolean 0: Disable AT over Ethernet
1: Enable AT over Ethernet
store
Boolean If store is 1 the new value is stored permanently.
Requires a reboot for the changes to take effect.
AT*AMLCR?
Get AT over layer 2 configuration
Syntax:
AT*AMLCR?
Example:
AT*AMLCR?<br>*AMLCR:<eth_type>,<enabled>
3.8.16 AT*AMREBOOT Reboot
AT*AMREBOOT
Reboot device
Syntax:
AT*AMREBOOT
Wireless Bolt
™
/ Wireless Bridge II
™
Reference Guide
SCM-1202-004 1.7 en-US