Instructions
Table Of Contents
- 1 Preface
- 2 Description
- 3 Installation
- 4 Configuration
- 4.1 General
- 4.2 Web Interface
- 4.2.1 System Overview
- 4.2.2 Easy Config
- 4.2.3 Network Settings
- 4.2.4 WLAN Settings - Client
- 4.2.5 WLAN Settings - Access Point
- 4.2.6 Bluetooth Settings – General
- 4.2.7 Bluetooth Settings – PANU Mode
- 4.2.8 Bluetooth Settings – NAP Mode
- 4.2.9 Bluetooth LE Settings
- 4.2.10 Firmware Update
- 4.2.11 AT Commands
- 4.2.12 System Settings
- 4.3 Factory Restore
- A Configuration Examples
- B Wireless Technology Basics
- C Technical Data
Configuration 17 (40)
4.2.4 WLAN Settings - Client
Fig. 9 WLAN Settings - Client
Enable
Enable/disable the WLAN interface.
Operating Mode Choose operation as WLAN Client or Access Point. If Access Point is selected, additional
settings will be available.
Channel Bands Choose to scan only the 2.4 GHz or 5 GHz channel band, or both (default).
The unit can be configured to scan on both the 2.4 GHz and 5 GHz channel bands but can only
communicate on one band at a time.
Scan for Networks Click to scan the selected frequency band(s) for discoverable WLAN networks.
Select a network from the dropdown menu to connect to it.
Connect to SSID
To connect manually to a network, enter its SSID (network name) here. This can be used
if the network does not broadcast its SSID.
Authentication Mode
Select the authentication/encryption mode required by the network.
Open = No encryption or authentication
Passkey
Enter the passkey when using WPA/WPA2-PSK or WEP64/128.
Username, Domain,
Passphrase
Authentication details when using LEAP or PEAP (WPA2 Enterprise).
Channel Select a specific channel to use when scanning for networks.
Auto = all available channels will be scanned (default).
See also WLAN Channels and World Mode (Client Mode only), p. 19
Anybus
®
Wireless Bolt
™
User Manual
SCM-1202-007 2.6 en-US