Manual
Table Of Contents
- Anybus® Communicator™ - Modbus TCP Server to EtherCAT Slave
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Communicator Configuration
- 6.1. Connect the Communicator
- 6.2. Access the Built-In Web Interface From HMS IPconfig
- 6.3. Access the Built-In Web Interface From a Web Browser
- 6.4. Communicator Built-In Web Interface Overview
- 6.5. Modbus TCP Settings
- 6.6. EtherCAT Settings
- 6.7. I/O Configuration
- 6.8. Apply Configuration
- 6.9. Configuration Notes
- 7. PLC Configuration
- 8. Verify Operation
- 9. Maintenance
- 10. Troubleshooting
- 11. Technical Data
10.3. Firmware Upgrade Error Management
If the rmware update process is interrupted or if the power is lost during the update process, the
Communicator goes into fallback mode.
The last working rmware is sll available on the ash, but it is not acve.
Procedure
To complete the interrupted rmware update:
1. Disconnect the Communicator from power.
Figure 46. Disconnect power
2. Reconnect the Communicator to power.
Figure 47. Reconnect power
Anybus
®
Communicator
™
- Modbus TCP Server to EtherCAT Slave Firmware Upgrade Error Management
Page 50 of 56 SCM-1202-192 Version 1.0