Manual
Table Of Contents
- Anybus® Communicator™ - Modbus TCP Server to EtherCAT Slave
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Communicator Configuration
- 6.1. Connect the Communicator
- 6.2. Access the Built-In Web Interface From HMS IPconfig
- 6.3. Access the Built-In Web Interface From a Web Browser
- 6.4. Communicator Built-In Web Interface Overview
- 6.5. Modbus TCP Settings
- 6.6. EtherCAT Settings
- 6.7. I/O Configuration
- 6.8. Apply Configuration
- 6.9. Configuration Notes
- 7. PLC Configuration
- 8. Verify Operation
- 9. Maintenance
- 10. Troubleshooting
- 11. Technical Data
3. While holding the reset buon, reconnect the Communicator to power.
Figure 44. Hold Reset buon and reconnect power
4. Release the reset buon.
The Communicator enters excepon state.
5. Reboot the Communicator.
Result
When the Communicator has successfully rebooted, the Communicator conguraon is reset to the factory
default conguraon or the current conguraon aer rmware upgrade.
To Do Next
To ensure that the Communicator built-in web-interface is synchronized.
1. Open the the Communicator built-in web interface.
2. Navigate to the Files & rmware page and click Revert.
Figure 45. Files & rmware, Revert
Reset to Factory Sengs Anybus
®
Communicator
™
- Modbus TCP Server to EtherCAT Slave
SCM-1202-192 Version 1.0 Page 49 of 56