Manual
Table Of Contents
- Anybus® Communicator™ - Modbus TCP Server to EtherCAT Slave
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Communicator Configuration
- 6.1. Connect the Communicator
- 6.2. Access the Built-In Web Interface From HMS IPconfig
- 6.3. Access the Built-In Web Interface From a Web Browser
- 6.4. Communicator Built-In Web Interface Overview
- 6.5. Modbus TCP Settings
- 6.6. EtherCAT Settings
- 6.7. I/O Configuration
- 6.8. Apply Configuration
- 6.9. Configuration Notes
- 7. PLC Configuration
- 8. Verify Operation
- 9. Maintenance
- 10. Troubleshooting
- 11. Technical Data
10.2. Reset to Factory Sengs
Before You Begin
Procedure
To reset the Communicator:
1. Disconnect the Communicator from power.
Figure 42. Disconnect power
2. Use a pointed object, such as a ballpoint pen to press and hold the Reset buon.
Figure 43. Press and hold Reset buon
Anybus
®
Communicator
™
- Modbus TCP Server to EtherCAT Slave Reset to Factory Sengs
Page 48 of 56 SCM-1202-192 Version 1.0