Manual
Table Of Contents
- Anybus® Communicator™ - Modbus TCP Server to EtherCAT Slave
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Communicator Configuration
- 6.1. Connect the Communicator
- 6.2. Access the Built-In Web Interface From HMS IPconfig
- 6.3. Access the Built-In Web Interface From a Web Browser
- 6.4. Communicator Built-In Web Interface Overview
- 6.5. Modbus TCP Settings
- 6.6. EtherCAT Settings
- 6.7. I/O Configuration
- 6.8. Apply Configuration
- 6.9. Configuration Notes
- 7. PLC Configuration
- 8. Verify Operation
- 9. Maintenance
- 10. Troubleshooting
- 11. Technical Data
10. Troubleshoong
10.1. Diagnoscs
10.1.1. I/O Data
On the Diagnoscs, I/O data page you can monitor how the data ow between the Modbus TCP side and the
EtherCAT side, including any congured endian conversions.
Figure 40. I/O data
The table can contain at most 10000 messages. When the limit is reached, the oldest messages are discarded
when new messages are added.
Switch between the OT networks
To switch between the networks, select Modbus TCP or EtherCAT.
Select how data is displayed
To choose if the data should be displayed in Hexadecimal, Decimal or ASCII, click Hex, Dec or Ascii.
Start and Stop Data ow
• To start the data ow, click Start.
• To end the data ow, click Stop.
Anybus
®
Communicator
™
- Modbus TCP Server to EtherCAT Slave Troubleshoong
Page 46 of 56 SCM-1202-192 Version 1.0