Manual
Table Of Contents
- Anybus® Communicator™ - Modbus TCP Server to EtherCAT Slave
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Communicator Configuration
- 6.1. Connect the Communicator
- 6.2. Access the Built-In Web Interface From HMS IPconfig
- 6.3. Access the Built-In Web Interface From a Web Browser
- 6.4. Communicator Built-In Web Interface Overview
- 6.5. Modbus TCP Settings
- 6.6. EtherCAT Settings
- 6.7. I/O Configuration
- 6.8. Apply Configuration
- 6.9. Configuration Notes
- 7. PLC Configuration
- 8. Verify Operation
- 9. Maintenance
- 10. Troubleshooting
- 11. Technical Data
9.3.4. Update Firmware
Before You Begin
Ensure that the Communicator is disconnected from the OT networks.
Procedure
Figure 39. Files & rmware page
To update the rmware:
1. On the Files & rmware page, click Upload.
2. In the Upload Firmware window, click Select rmware (.hi).
3. In the Open dialog box, browse to and select the rmware le and click Open.
4. To start the rmware upgrade, click Update rmware.
The rmware le is validated and transferred.
Result
• If the rmware le pass the validaon: The rmware is upgraded and then the Communicator automacally
reboots, for the upgrade to take eect.
• If the rmware le is rejected: An error message appear.
Firmware Management Anybus
®
Communicator
™
- Modbus TCP Server to EtherCAT Slave
SCM-1202-192 Version 1.0 Page 45 of 56