Manual
Table Of Contents
- Anybus® Communicator™ - Modbus TCP Server to EtherCAT Slave
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Communicator Configuration
- 6.1. Connect the Communicator
- 6.2. Access the Built-In Web Interface From HMS IPconfig
- 6.3. Access the Built-In Web Interface From a Web Browser
- 6.4. Communicator Built-In Web Interface Overview
- 6.5. Modbus TCP Settings
- 6.6. EtherCAT Settings
- 6.7. I/O Configuration
- 6.8. Apply Configuration
- 6.9. Configuration Notes
- 7. PLC Configuration
- 8. Verify Operation
- 9. Maintenance
- 10. Troubleshooting
- 11. Technical Data
6.7. I/O Conguraon
Figure 20. I/O conguraon page
Enter the desired Size for the network input data and output data.
By default, the Communicator is set to use the same I/O sizes for both the Modbus TCP and the EtherCAT
networks.
To congure dierent sizes for the networks, deselect the Same I/O sizes for both networks checkbox.
Endian Swap
Big-endian
The big-endian format places the most signicant byte of the data at the byte with the lowest memory address.
Lile-endian
The lile-endian format places the least signicant byte of the data at the byte with the lowest memory address.
I/O Conguraon Anybus
®
Communicator
™
- Modbus TCP Server to EtherCAT Slave
SCM-1202-192 Version 1.0 Page 27 of 56