Manual
Table Of Contents
- Anybus® Communicator™ - Modbus TCP Server to EtherCAT Slave
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Communicator Configuration
- 6.1. Connect the Communicator
- 6.2. Access the Built-In Web Interface From HMS IPconfig
- 6.3. Access the Built-In Web Interface From a Web Browser
- 6.4. Communicator Built-In Web Interface Overview
- 6.5. Modbus TCP Settings
- 6.6. EtherCAT Settings
- 6.7. I/O Configuration
- 6.8. Apply Configuration
- 6.9. Configuration Notes
- 7. PLC Configuration
- 8. Verify Operation
- 9. Maintenance
- 10. Troubleshooting
- 11. Technical Data
Naming the Host
Figure 16. IP Sengs Hostname
You can label the Communicator.
• The maximum allowed length of the Hostname is 64 characters.
• No symbol characters, punctuaon characters, or whitespace are permied.
• Write the Hostname as one single word.
6.5.2. Timeout Time Sengs
Figure 17. Modbus TCP page, Timeout mes
Connecon Timeout
Specify how long a Modbus TCP connecon may be idle before it is closed by the Communicator.
The default value is 60 seconds.
Process Data Acve Timeout
Specify the maximum allowed me between two incoming messages in steps of 10 ms.
If this me is exceeded, the high level network is considered to be oine.
The data sent to the sub-network is frozen.
A value of 0 disables this feature, i.e. the high level network can never go oine.
The default value is 0 ms.
Modbus TCP Sengs Anybus
®
Communicator
™
- Modbus TCP Server to EtherCAT Slave
SCM-1202-192 Version 1.0 Page 25 of 56