Manual
Table Of Contents
- Anybus® Communicator™ - Modbus TCP Server to EtherCAT Slave
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Communicator Configuration
- 6.1. Connect the Communicator
- 6.2. Access the Built-In Web Interface From HMS IPconfig
- 6.3. Access the Built-In Web Interface From a Web Browser
- 6.4. Communicator Built-In Web Interface Overview
- 6.5. Modbus TCP Settings
- 6.6. EtherCAT Settings
- 6.7. I/O Configuration
- 6.8. Apply Configuration
- 6.9. Configuration Notes
- 7. PLC Configuration
- 8. Verify Operation
- 9. Maintenance
- 10. Troubleshooting
- 11. Technical Data
To Congure IP Sengs Manually
Figure 15. Modbus TCP IP Sengs, DCHP disabled
1. Deselect the DHCP enabled checkbox.
2. Congure the IP sengs.
Seng Descripon
IP address The Modbus TCP network IP address in IPv4 dot-decimal notaon
Subnet mask The Modbus TCP network Subnet mask in IPv4 dot-decimal notaon.
Gateway address The Modbus TCP network Gateway address in IPv4 dot-decimal notaon.
If there is no gateway available, set the Gateway address to: 0.0.0.0
Primary DNS server The Modbus TCP network Primary DNS in IPv4 dot-decimal notaon.
Secondary DNS server The Modbus TCP network Secondary DNS in IPv4 dot-decimal notaon.
DHCP Enabled
If you change a value and click Refresh, the value is reset to the last applied value.
Anybus
®
Communicator
™
- Modbus TCP Server to EtherCAT Slave Modbus TCP Sengs
Page 24 of 56 SCM-1202-192 Version 1.0