Manual
Table Of Contents
- Anybus® Communicator™ - Modbus TCP Server to EtherCAT Slave
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Communicator Configuration
- 6.1. Connect the Communicator
- 6.2. Access the Built-In Web Interface From HMS IPconfig
- 6.3. Access the Built-In Web Interface From a Web Browser
- 6.4. Communicator Built-In Web Interface Overview
- 6.5. Modbus TCP Settings
- 6.6. EtherCAT Settings
- 6.7. I/O Configuration
- 6.8. Apply Configuration
- 6.9. Configuration Notes
- 7. PLC Configuration
- 8. Verify Operation
- 9. Maintenance
- 10. Troubleshooting
- 11. Technical Data
6.3. Access the Built-In Web Interface From a Web Browser
Before You Begin
NOTE
The Communicator conguraon port default IP address is 192.168.0.10.
NOTE
To access the Communicator built-in web interface, ensure that Port 80 TCP is open in your Firewall.
This applies to any Firewall between the web browser and the gateway.
NOTE
When you change to a stac IP address on your computer, internet access may be lost.
Procedure
1. On the PC accessing the Communicator built-in web interface, set a stac IP address within the same IP
address range as the Communicator IP address.
2. Open a web browser.
3. Click to select the Address bar and enter the Communicator IP address.
4. To open the built-in web interface Home page, press Enter.
Access the Built-In Web Interface From a Web Browser Anybus
®
Communicator
™
- Modbus TCP Server to EtherCAT Slave
SCM-1202-192 Version 1.0 Page 21 of 56