Manual
Table Of Contents
- Anybus® Communicator™ - Modbus TCP Server to EtherCAT Slave
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Communicator Configuration
- 6.1. Connect the Communicator
- 6.2. Access the Built-In Web Interface From HMS IPconfig
- 6.3. Access the Built-In Web Interface From a Web Browser
- 6.4. Communicator Built-In Web Interface Overview
- 6.5. Modbus TCP Settings
- 6.6. EtherCAT Settings
- 6.7. I/O Configuration
- 6.8. Apply Configuration
- 6.9. Configuration Notes
- 7. PLC Configuration
- 8. Verify Operation
- 9. Maintenance
- 10. Troubleshooting
- 11. Technical Data
6. Communicator Conguraon
6.1. Connect the Communicator
Procedure
Connect to Modbus TCP and EtherCAT network
Network 1 = Modbus TCP Network 2 = EtherCAT
Connect to PC and Power
1. Connect an Ethernet cable between the Communicator and your PC.
2. Connect the Communicator to a power supply.
Anybus
®
Communicator
™
- Modbus TCP Server to EtherCAT Slave Communicator Conguraon
Page 18 of 56 SCM-1202-192 Version 1.0