Manual
Table Of Contents
- Anybus® Communicator™ - Modbus TCP Server to EtherCAT Slave
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Communicator Configuration
- 6.1. Connect the Communicator
- 6.2. Access the Built-In Web Interface From HMS IPconfig
- 6.3. Access the Built-In Web Interface From a Web Browser
- 6.4. Communicator Built-In Web Interface Overview
- 6.5. Modbus TCP Settings
- 6.6. EtherCAT Settings
- 6.7. I/O Configuration
- 6.8. Apply Configuration
- 6.9. Configuration Notes
- 7. PLC Configuration
- 8. Verify Operation
- 9. Maintenance
- 10. Troubleshooting
- 11. Technical Data
5.2. DIN Rail Mounng
IMPORTANT
The equipment must be electrically grounded through the DIN rail for EMC compliance. Make sure
that the equipment is correctly mounted on the rail and that the rail is properly grounded.
Figure 4. Aach the Communicator on the DIN rail
To aach the Communicator on the DIN rail:
1. Insert the upper end of the DIN rail clip into the DIN rail.
2. Push the boom of the DIN rail clip into the DIN rail.
DIN Rail Mounng Anybus
®
Communicator
™
- Modbus TCP Server to EtherCAT Slave
SCM-1202-192 Version 1.0 Page 9 of 56