Instructions

4.4.2. Set a Node Address with Rotary Switches
About the Rotary Switch Sengs
To set a node address for the PROFIBUS server, use the rotary switches located on the top
front of the Communicator .
TIP
Use Windows Calculator (or similar applicaon) to convert between
hexadecimal (hex) and decimal (dec).
• The default node address seng is 000.
• When the node address seng is 000, you can se the node address via the
Communicator built-in web interface.
• The node address values are set in hexadecimal (hex).
• Minimum value is 00.
• Supports PROFIBUS node addresses 0-126 Dec (0-7E Hex).
• Each node address may only occur once in the network.
• The node address is read from the center rotary switch x16 to the front rotary switch x1.
• The rear rotary switch is not used, ensure that it is set to 0.
Rotary Switch Sengs Anybus
®
Communicator
™
- PROFIBUS to Modbus
RTU/Serial
SP2980 1.2 Page 11 of 28