Instructions
Table Of Contents
- Anybus® Communicator™ - PROFIBUS to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Apply Configuration
- 7.12. To Use an Existing Configuration
- 7.13. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
5.3. Connect to PROFIBUS Network
Figure 12. Connect to PROFIBUS network
1. Connect the Communicator to your PROFIBUS network.
PROFIBUS Connector Pin Descripon
1 Shield
2 Not used
3 Line B
4 RTS
5 GND Bus
6 +5 V Bus Out
7 Not used
8 Line A
9 Not used
Housing PE
To Do Next
Connect the Communicator to the Serial RS-232/485 network, set the node address on the rotary switches and
connect to power.
Check LED status, refer to Communicator LED Indicators (page 96).
Connect to PROFIBUS Network Anybus
®
Communicator
™
- PROFIBUS to Modbus RTU/Serial
SCM-1202-177 1.2 Page 15 of 134