Instructions
Table Of Contents
- Anybus® Communicator™ - PROFIBUS to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Apply Configuration
- 7.12. To Use an Existing Configuration
- 7.13. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
Procedure
Figure 98. Read Barcode Data Parameter
1. Add an Empty consume template and select it.
2. Name the template Read Barcode Data.
3. In the Frame editor, add four frame eld with the following sengs:
Table 14. Consume frame elds
Frame
elds
Name Type Value Fixed
eld
Maximum
payload
length
Process
data
delimiter
Subnet
delimiter
End
paern
Variable
data
Barcode
Data
N/A N/A Yes, set
here
31 bytes None None 0
Constant Carriage
Return
character
(CR)
Byte (1
byte)
13 Yes, set
here
N/A N/A N/A N/A
Constant Line Feed
character
(LF)
Byte (1
byte)
10 Yes, set
here
N/A N/A N/A N/A
Anybus
®
Communicator
™
- PROFIBUS to Modbus RTU/Serial Barcode Scanner - Custom Produce/Consume Use Case
Page 114 of 134 SCM-1202-177 1.2