Instructions

DF1 Protocol Mode 89
Doc: HMSI-27-314, Rev. 3.10Anybus Communicator EtherNet/IP / Modbus-TCP User Manual
16.4 Node Parameters
To gain access to the parameters described in this section, select a node in the navigation section. For
more information about nodes, see “Nodes” on page 67.
16.5 Services
Services are commands that can be stored and reused. The user configures each slave with services that
can be issued from the master. A total of 50 services are allowed.
The Anybus Communicator supports a selection of DF1 commands. When the gateway is going to ex-
ecute a service, it automatically chooses the appropriate DF1 command(s) that are used to perform the
service on the selected DF1 node type.
Parameter Description Valid Settings
Checksum Selects the type of checksum on the network. BCC
CRC (default)
Slave Address The value entered here sets the node address. 0-254
Type The PLC type of the slave PLC-5
SLC500
MicroLogix