Instructions

About the Anybus Communicator for EtherNet/IP 15

Doc: HMSI-27-314, Rev. 3.10Anybus Communicator EtherNet/IP / Modbus-TCP User Manual

1.4 Hardware Installation

Perform the following steps to install the Anybus Communicator module:

1. Snap the gateway on to the DIN-rail.

The DIN-rail mechanism works as follows:

To snap the ABC on, first press it downwards (1) to compress the spring

in the DIN-rail mechanism, then push it against the DIN-rail as to make

it snap on (2)

To snap the ABC off, push it downwards (1) and pull it out from the DIN-

rail (2), as to make it snap off from the DIN-rail

2. Connect the gateway to an Ethernet network.

3. Connect the gateway to the serial sub-network.

4. Connect the gateway to the PC via the configuration cable.

5. Connect the power cable and apply power.

6. Start the Anybus Configuration Manager program on the PC.

(The Anybus Configuration Manager software will automatically attempt to detect the serial port.

If unsuccessful, select the correct port manually in the “Port”-menu)

7. Configure the gateway using the Anybus Configuration Manager and download the

configuration.

8. Set up the EtherNet/IP communication according to the gateway configuration.