Instructions

About the Anybus Communicator for EtherNet/IP 14
Doc: HMSI-27-314, Rev. 3.10Anybus Communicator EtherNet/IP / Modbus-TCP User Manual
1.3 Configuration Switches
If set to a nonzero value, the configuration switches forces the Anybus Communi-
cator to use an IP address in the range 192.168.0.1 - 192.168.0.255.
If set to zero, these settings are specified by the system file ‘ethcfg.cfg’, or by settings
in Anybus Configuration Manager.
Note that the switches are read once during startup; any changes require a reset in
order to have effect.
See also...
• “Basic Network Configuration” on page 37
• “Basic Settings” on page 64
SW1 SW2 SW3 SW4 SW5 SW6 SW7 SW8 DHCP Subnet Gateway IP
OFF OFF OFF OFF OFF OFF OFF OFF (settings determined by ‘ethcfg.cfg’)
OFF OFF OFF OFF OFF OFF OFF ON OFF 255.255.255.0 192.168.0.255 192.168.0.1
OFF OFF OFF OFF OFF OFF ON OFF OFF 255.255.255.0 192.168.0.255 192.168.0.2
... ... ... ... ... ... ... ... ... ... ... ...
ON ON ON ON ON ON ON OFF OFF 255.255.255.0 192.168.0.255 192.168.0.254
ON ON ON ON ON ON ON ON (invalid setting)