Instructions

About the Anybus Communicator for EtherNet/IP 12

Doc: HMSI-27-314, Rev. 3.10Anybus Communicator EtherNet/IP / Modbus-TCP User Manual

1.1 External View

For wiring and pin assignments, see “Connector Pin Assignments” on page 124.

A: Ethernet Connectors

These connectors are used to connect the Anybus Com-

municator to the network.

See also...

- “Ethernet Connector” on page 124

B: Configuration Switches

See also...

- “Configuration Switches” on page 14

C: Status LEDs

See also...

- “Status LEDs” on page 13

D: PC-connector

This connector is used to connect the gateway to a PC for

configuration and monitoring purposes.

See also...

- “PC Connector” on page 125

E: Sub-network Connector

This connector is used to connect the gateway to the serial sub-network.

See also...

- “Sub-network Interface” on page 126

F: Power Connector

This connector is used to apply power to the gateway.

See also...

- “Power Connector” on page 124

G: DIN-rail Connector

The DIN-rail mechanism connects the gateway to PE (Protective Earth).

See also...

- “Configuration Switches” on page 14