Instructions

Doc: HMSI-27-306, Rev. 3.11Anybus Communicator PROFIBUS User Manual
Chapter 4
4. Basic Settings
4.1 Fieldbus Settings
(Select “Fieldbus” in the Navigation Section to gain access to the
parameters described in this section).
General
During start-up the fieldbus interface of the gateway is initialized to fit the configuration created in the
Anybus Configuration Manager. Optionally, some initialization parameters can be set manually to pro-
vide better control over how the data shall be treated by the gateway.
Fieldbus Type
The Anybus Configuration Manager supports a wide range of net-
working systems. Make sure that this parameter is set to “Profibus-
DP”.
IO Sizes
(This setting is not applicable on this network and is therefore disa-
bled in the Anybus Configuration Manager)
Fieldbus Type