User manual

Advanced Configuration 40 (46)
System Configuration File (chip.ini)
Parameter Description Valid range Default value [IP] ADDRESS IP address of device 0.0.0.0 - 255.255.255.255 Not set NETMASK Subnet mask of device 0.0.0.0 - 255.255.255.255 Not set GATEWAY IP address of device 0.0.0.0 - 255.255.255.255 Not set DHCP Enabling DHCP look-up 0, 1 1 TCPIPMEM Memory for the webserver (kB) 60–1000 280 [DEVICE] NAME Name of device shown in Net discover Text (max. 20 characters) Anybus M-Bus/MTCP
20 (80)
[CONFIG] MBUS_BAUDRATE Baud rate for serial M-Bus communication 2400 MBUS_DATABITS Data bits for serial M-Bus communication 7, 8 8 MBUS_DEBUGOUT Enables output of raw data to STDOUT 0, 1 0 MBUS_ENABLE Enables the M-Bus interface 0, 1 1 MBUS_FREEZESTORAGENUM Storage number for meter data on Freeze command 0 - 4294967295 0 MBUS_FULLTIMEOUT Maximum timeout for reading a meter (ms) 0-65535 10000 MBUS_IDLETIMEOUT Idle timeout for detecting end of communication 0-65535 100 MBUS_MAXMULTIPAGE Limits number of pages for multipage request 0 - 255 10 MBUS_MAXPRIMARYADDRESS Upper limit of address range for M-Bus primary scan 0 - 250 250 MBUS_MAXRETRY Number of retries for a M-Bus or multipage request 0 - 255 3 MBUS_MINPRIMARYADDRESS Lower limit of address range for M-Bus primary scan 0 - 250 0 MBUS_PARITY M-Bus parity: 0 = no, 1 = odd, 2 = even, 3 = mark, 4 = space 0 - 4 2 MBUS_RAWLOGENABLE Enables raw data log to drive B: 0, 1 0 MBUS_REQUESTMODE Defines request sequence for readout DEFAULT,EXT,ONLY,FREEZE DEFAULT MBUS_RESETDISABLE Disables reset command 0, 1 0 MBUS_RESETMODE Reset mode: 0 = Reset after select, 1 = Reset prior to select, 2 = No reset 0 - 2 0 MBUS_SCANMODE Scan mode for M-Bus PRIMARYSCAN,
SECONDARYSCAN, SECONDARYSCANALLOC, SECONDARYSCANREVERSE, SECONDARYSCANALLOCRE- VERSE
SECONDARYSCAN
MBUS_ SECMASKMANUFACTURER
Predefined manufacturer ID for secondary scan Exactly 4 characters, 0-9 each
or 0xFFFF
0xFFFF
M-Bus to Modbus-TCP Gateway User Manual SCM-1202-0096-EN 2.1