User manual

Acquiring and Processing Meter Data 25 (46)
Adding Meters Manually
Fig. 15 Adding a meter
Meters that are connected but not found during a scan can be added manually by clicking on
the Add button in the Meter tab. The configuration of the meter must be known to be able to
add it manually.
The fields in the Add meter dialog correspond to the fields in the meter list. The following
parameters can be edited:
Serial Serial number of the meter (must be 8 digits)
Link Primary (link layer) address
Cycle (s) Readout interval in seconds (0 = use general readout interval)
User label User specific description of the meter
Modbus register Modbus register address
Number of meters If creating multiple meters with the same configuration
See also Meter Tab, p. 11.
Click OK to save the configuration. The new meter(s) will now appear in the list.
M-Bus to Modbus-TCP Gateway User Manual SCM-1202-0096-EN 2.1