User manual

Configuration 13 (46)
Editing Entries
Fig. 7 Editing meter and value entries
Meter and value entries can be configured by double-clicking the entry or by right-clicking the
entry and selecting Edit. The fields in the Edit dialog correlate with the fields in the meter list.
Depending on the used interface some fields may be disabled for editing.
The readout interval can be set independently for each meter in the field Cycle. If no value is
entered the global readout interval will be used, see Configuration Tab, p. 14.
Each meter or value entry can be assigned a User label for application-specific use. The label
can consist of up to 50 characters including spaces.
Valid characters in user labels:
A-Z, a-z, 0-9, ! § $ % & / ( ) = ? + , . *
Invalid characters: < > “ ”
Modbus Address Allocation
The Modbus register address can be assigned or reset for a single meter or for all meters by
right-clicking on the entry and selecting Allocate or Deallocate. If duplicate addresses are
detected an error message will be shown when the configuration is saved.
M-Bus to Modbus-TCP Gateway User Manual SCM-1202-0096-EN 2.1