User manual

Configuration 12 (46)
The default configuration for each meter is applied immediately after scanning. Additional
changes to the configuration must be saved manually.
When activating or deactivating a meter, its meter values will automatically be enabled or
disabled according to the hierarchy. An inactive meter will be activated when one of its meter
values is enabled.
Hold down the SHIFT or CTRL keys to select multiple meters or meter values.
Meter tab fields
Field Description Writable
Interface Interface of meter (M-Bus) No
S Entry status
E = Value has been edited
* = Value display is limited in the configuration
! = Unable to read value
No
Serial Serial number of meter No
MAN Manufacturer of meter (3-letter abbreviation) No
Medium Medium of meter No
Version Version number of meter No
Link Primary address No
Value Meter reading or measurement value No
Scale Scale factor (scientific notation) No
Unit Unit No
Cycle Readout interval in seconds (0 = use general readout interval) Yes
User label User specific description of meter or value.
Included in export of CSV data, allows application specific mapping.
Yes
Description Description of meter value No
Register Modbus register address in steps of 10 Yes
The arrangement of data in the meter list corresponds to the order of the data in the M-Bus
protocol. The meaning of the values can thus be compared directly with the data sheet of the
meter. It is also possible to assign the meter values to the raw data of the meter.
Timestamps
Timestamp values transmitted within the M-Bus protocol are automatically assigned to the
other meter values where possible. This means that some of the timestamps may not appear in
the list. To enable the display of all timestamps values in the list, set the system configuration
parameter MUC_SHOWTIMESTAMPENTRIES to 1. See Configuration Files, p. 39.
Webserver capacity error
If a scan or a change in the meter list is terminated with the error message “Webserver capacity
exceeded”, see Troubleshooting, p. 31.
M-Bus to Modbus-TCP Gateway User Manual SCM-1202-0096-EN 2.1