User manual

Installation 8 (46)
3.4 Network Settings
The Anybus M-Bus to Modbus-TCP gateway is normally configured using the built-in web
interface. The IP address of the gateway must be in the same subnet range of your local
network as the computer used for configuration.
Default network settings
Static IP address 192.168.1.101
Subnet mask 255.255.255.0
Default gateway 192.168.1.254
The network settings can be configured automatically from a DHCP server or manually using
the configuration tool Net discover. The settings can also be changed from the web interface
after you have logged in.
Make sure that you have all necessary information about your local network before
starting installation. Contact your network administrator if in doubt.
Changing Network Settings with Net discover
1. Download Net discover from www.anybus.com/support and install it on your computer.
2. In Net discover, right-click on the entry for the device and select the configuration option.
Fig. 3 Net discover
3. If the network uses static IP addressing, enter the desired IP address, subnet mask and
default gateway address. If the network uses dynamic IP addressing, check the DHCP
checkbox. Contact your network administrator if in doubt.
Do not enable DHCP if there is no active DHCP server on the network.
4. Click on Send to download the IP settings to the gateway.
Right-click on the gateway in Net discover and select HTTP Web to open the web interface in
your default browser. You can also access the web interface by entering the IP address in the
address field of any standard web browser.
Additional features of Net discover are described in Advanced Configuration, p. 37.
M-Bus to Modbus-TCP Gateway User Manual SCM-1202-0096-EN 2.1