Instructions

Configuration 11
Anybus M-Bus to Modbus-TCP Gateway User Manual Doc: HMSI-27-300, Rev: 1.10
Editing meter and value entries
Meter and value entries can be configured by right-clicking the entry and selecting
Edit in the context
menu, or by double-clicking the entry. The fields in the Edit dialog correlate with the fields in the meter
list. Depending on the used interface some fields may be disabled for editing.
The readout interval in seconds can be set independently for each meter in the field
Cycle. If no value
is entered the global readout interval is used, see 3.1.3
Configuration tab.
Each meter or value entry can be assigned a
User label for application-specific use. The User label can
consist of a maximumof 50 characters including spaces.
Modbus address allocation
The Modbus register address can be assigned or reset for a single meter or all meters via the context
menu choices
Allocate and Deallocate. When the configuration is saved, the Modbus addresses will be
checked for duplicates. If duplicate addresses are detected an error message will be shown.
Buttons at bottom of page
Readout will update all values regardless of their normal readout interval. This momentary readout may
take some time to create depending on the number of meters that are connected. The normal readout
cycle is not affected by a momentary readout.
Delete will delete the selected entry in the meter list. Individual meter value entries can not be deleted.
Reload discards the changes made on the page and reloads the currently active settings.
Save saves the changes and reinitializes the gateway.
Valid characters in User Label:
A-Z, a-z , 0-9
! § $ % & / ( ) = ? + , . *
Unvalid characters:
< > “ ”