User's Manual
Table Of Contents
- Chapter 1:INTRODUCTION
- Chapter 2:INDICATIONS, CONTRAINDICATIONS AND WARNINGS
- Chapter 3:WIRING AND CONTROL PANEL OF CONSOLE
- Chapter 4:OPERATION INSTRUCTION FOR ESNAVI SOFTWARE
- 4.1Installing Software
- 4.2Uninstalling Software
- 4.3Basic Operation of Software
- Chapter 5:USAGE OF CAPSULE
- Chapter 6:USAGE OF DATA RECORDER
- Chapter 7:INSTALLATION AND TRAINING
- Chapter 8:MAINTENANCE
- Chapter 9:WARNINGS, CAUTIONS AND TROUBLESHOOTING
- 9.1ESNavi Error Messages
- 9.1.1.1.1.Check if camera is connected firmly
- 9.1.1.1.2.Equipment initialization error
- 9.1.1.1.3.Port "COM7" does not exist
- 9.1.1.1.4.Video monitoring connection fails
- 9.1.1.1.5.Port "COM8" does not exist
- 9.1.1.1.6.Serial port initialization error
- 9.1.1.1.7.Port "COM4" does not exist
- 9.1.1.1.8.Cannot connect to Data Recorder
- 9.1.1.1.9.Password error
- 9.1.1.1.10."Print error" prompt box
- 9.2Problems with Translational Rotation Platform
- 9.3Problems with Capsule
- 9.4Problems with Data Recorder
- 9.5Problems with Locator
- 9.1ESNavi Error Messages
- Chapter 10:TECHNICAL SPECIFICATIONS
- Chapter 11:SYSTEM LABELING
NaviCam
®
Stomach Capsule User Manual Page | 107
AnX Robotica Corp. UM-NCES-ST-01 Rev 1
indicator.
6.3.3 Turn-off the Locator
Press and hold the “Power Switch” for more than 5 seconds and the Locator will shut
down. All the indicators will be off after the shutdown. The Locator will be
automatically shuts down after 10 minutes without any operation.
6.3.4 Charge
The Locator uses a battery to supply power. When the battery voltage is low, the
flashing frequency of the working indicator will get lower. When the flashing changes
to one time per three seconds, The Locator needs to charge through the power port.
During the charging process, the charging indicator is always on, and is automatically
turned off after being fully charged.
Warning
The Locator can only be charged using a charger that comes with the unit.
Charging can only be performed by the physician/operator. Patients shall not
have access to the adaptor.