Setup guide

Turn off display
Switches the display into energy saving mode. Multi-monitor configurations are not supported.
No parameters.
Change Display Mode
Change the current display mode. The dropdown box lists the available modes.
Audio control
Audio Mode
Cycles through sound controls. Starting with Volume Control, any subsequent button push within two seconds will
call adjustment mode for the following controls (if available for the soundcard and selected input line): Pan, Bass,
Treble, Fader. To adjust the current mode, use Adjust Up/Right and Adjust Down/Left. This function is similar to
those seen in many car stereos.
Adjust Up/Right
Increases the value of the current audio mode. If the last Audio Mode command has timed out (after two
seconds), the volume of the selected mixer input line will be increased.
Adjust Down/Left
Decrease the value of the current audio mode If the last Audio Mode command has timed out (after two seconds),
the volume of the selected mixer control line will be decreased.
Before using this action, test your system by saving all open documents and putting it into standby mode
manually. Many badly written device drivers may prevent the system from waking up again properly.
Field Required ? Value
ModeYesSelect the desired display resolution from the dropdown list.
Field Required ? Value
MixerYesSelect the output line from the dropdown list
Field Required ? Value
MixerYesSelect the output line from the dropdown list
AccelNo
Acceleration level ( 1..20 ). Adjust this value to let the volume
increase more ore less faster. If not applied, a default acceleration
level is used.