Specifications
TACO BELL STEAMER TBS-2X & TBS-1X
10
P/N 1010698 Rev. E 03/04
11
TACO BELL STEAMER TBS-2X & TBS-1X
P/N 1010698 Rev. E 03/04
OPERATION (continued)
Operating Instructions
IMPORTANT: Steam generator must be calibrated
before initial use. See the section titled Calibration
in the Installation section of this manual.
1. Turn on the Rocker Switch (power On/Off)
(Figure 3).
2. Allow the unit to preheat for approximately 20-30
minutes.
IMPORTANT: The green light will flash dur-
ing warm-up. The flashing green ready light will
become steady when the unit is up to tempera-
ture. If green light continues to flash after warm-
up, or starts to flash during operation, see the
TROUBLESHOOTING section in this manual.
IMPORTANT: Do not push the Cycle Start button
during warm-up. The flashing green light indicates
unit is not up to temperature.
3. Pull out the Spatula and place the product to be
steamed onto the Spatula.
4. Push the Spatula fully into the steamer.
5. Press and release the Cycle Start button The
green “Ready” light will go out and the yellow
“Steaming” light will come on and remain lit for
the entire steaming cycle.
6. At the end of the steaming cycle (approximately 7
seconds), an audible signal will sound for 3 sec-
onds and the green “Ready” light will come back
on. These signals inform the operator that the
product is ready for serving.
7. Remove the steamed product.
Figure 3. Operating Controls
Yellow Steaming Light
Green Ready Light
Rocker Switch
(Power On/Off)
Cycle Start
Button
WARNING
To avoid injury, use caution when pulling spatula
out from unit. Be sure to allow steam to escape
before putting hands or face over the steamer.
Hi-Limit Thermostat
A hi-limit thermostat will turn off electrical power to the
generator and Transformer circuits if the unit overheats.
Turn unit off and allow to cool; the hi-limit thermostat
will automatically reset when the unit cools down. If
the unit continues to shut off due to overheating, con
-
tact your Roundup authorized service agency.