Specifications
Taco Bell STeamer TBS-2X & TBS-1X
18
P/N 1010698 Rev. G 06/08
1 0011229 Top Cover Assy. 1
0011198 Top Cover Assy. 1
6 0503085 Cover, Generator 1 2
7 0503592 Diffuser 1 2
8 0300129 Stud 1 2
(Incl. #7, 8, 49, 56, &
10 4010137 Power Switch 1 2
11 0021110 Corner Filler 4 4
12 4060363 Indicator Light, Yellow,
(Steaming Light) 1 2
13 4060362 Indicator Light, Green
(Ready Light) 1 2
14 4010166 Switch, Cycle Start 1 2
15 0503315 Liner, Cavity 1 2
16 0020341 Spatula 1 2
(Incl. parts for 4 legs) 1 1
20 4070113 Control Board 1 2
21 4050135 Thermocouple Assy. 1 2
23 4040145 Solenoid Valve, 24 VAC 1 2
24 2000202 Tube, Inlet 1 2
25 2000203 Tube, Restrictor 1 2
27 2190107 Pipe, Teflon (see Note 2) 2 4
28 2080117 Connector,
29 7000139 Connector,
32 0700452 Power Cord 1 2
35 0021133 Chimney 1 1
0021136 Chimney 1 1
36 0700554 Wire Set (not shown) 1 2
(Includes #38, 50, & 51)
38 100P967 Label, Marking 1 2
39 2040146 Tee, Female 1 2
40 2040145 Elbow, Female 1 2
41 7000319 Transformer 1 2
42 0503093 Retainer, Thermocouple 1 2
43 1000975 Label, Control Panel 1 2
44 0503171 Bracket, Mounting 1 2
45 2040103 Valve Connector 1 2
46 308P103* Screw, #8-32 x 1/4” 1 1
47 308P105* Screw, #8-32 x 1/2” 1 1
48 308P104* Screw, #8-32 x 3/8” 1 1
49 306P136* Screw, #8-32 x 5/8” 1 1
50 306P123* Screw, Stainless Steel,
#6-32 x 7/8” 1 1
54 300P102* Nut, Tinnerman, #8-32 1 1
55 306P134 Screw, #6-32 x 3/8” 3 3
56 325P170* Wingnut, Cast Iron, 1/4”-20 1 1
57 020P117* O-ring 1 1
58 362P102* Lock Washer, Toothed 1 1
60 7000299 Nut (3-Pak) See Note 1 1 1
(Incl. #24, 25, 39, 40, & 45)
* Only available in packages of 10.
NOTE 1: This special wrench nut is required to
separate the stem from the solenoid valve on older
solenoid valves
NOTE 2: Always use Teflon® tape on threads and
tighten until very snug.
No.
TBS-1X TBS-2X
No.
TBS-1X TBS-2X
REPLACEMENT PARTS (continued)