Specifications
11
Taco Bell STeamer TBS-2X & TBS-1X
P/N 1010698 Rev. G 06/08
1. Turn the power off, unplug the power cord(s), and
allow the unit to cool down before proceeding.
hose clamp connections for leakage. If leakage
is apparent, tighten all clamps or replace part if
required.
3. Remove the Top Cover, Spatula(s), and Liner(s)
(Figure 7).
4. Remove Chimney from rear of unit by sliding
upward and away from unit (Figure 7).
5. Clean the Top Cover, Spatula(s), Liner(s), and
Chimney in hot soapy water, rinse in clear water,
and wipe dry.
6. Clean the chamber(s) of any product spills.
7. Clean entire unit with a clean, hot, damp cloth
(not dripping wet) and wipe dry.
8. Re-install Chimney, Liner(s), Spatula(s), and Top
Cover.
MAINTENANCE
WARNING
Turn the power off, unplug the power cord, and
allow the unit to cool down before performing
any service or maintenance. The TBS-2X has two
power cords. Make sure both pwoer cords are
unplugged.
CAUTION
Chlorides or phosphates in cleaning agents (e.g.
bleach, sanitizers, degreasers or detergents)
could cause permanent damage to stainless steel
equipment. The damage is usually in the form of
discoloration, dulling of metal surface finish, pits,
voids, holes, or cracks. This damage is perma-
nent and NOT covered by warranty. The following
tips are recommended for maintenance of your
stainless steel equipment:
Always use soft, damp cloth for cleaning, rinse
with clear water and wipe dry. When required,
always rub in direction of metal polish lines.
soap, detergent, and water.
vinegar solution.
using soap and water.
vinegar solution.
Figure 7. Steamer Components
Spatula
Chimney
Liner
Generator
Cover
Steam Generator
Top Cover
Wing Nut
CAUTION
materials. The use of these may cause damage to
the stainless steel finish.
CAUTION
If a chemical cleaner is used, be sure it is safe to
use on cast aluminum. Observe all precautions
and warnings on product label.
NOTE: Frequency of cleaning is determined by
water conditions, usage, and water filter systems.
Steam
Ports