Specifications
Taco Bell STeamer TBS-2X & TBS-1X
10
P/N 1010698 Rev. G 06/08
OPERATION
Operating Instructions
NOTE: Steam generator must be calibrated before
initial use. See the section titled Calibration in the
Installation section of this manual.
1. Turn the power on and allow the unit to preheat for
approximately 20-30 minutes (Figure 6).
NOTE: The Green Ready Light (Figure 6) will flash
during warm-up. The flashing light will become
steady when the unit is up to temperature. If the
Green Ready Light continues to flash after warm-
up, or starts to flash during operation, see the
Troubleshooting section in this manual.
-
ton during warm-up. The flashing Green Ready
Light indicates unit is not up to temperature. If the
CYCLE STARTbutton is pressed while the green
light is flashing, nothing will happen.
3. Pull out the Spatula and place the product to be
steamed onto the Spatula.
4. Push the Spatula fully into the steamer.
5. Press and release the CYCLE START button
The Green Ready Light will go out and the Yellow
Steaming Light will come on and remain lit for the
entire steaming cycle.
6. At the end of the steaming cycle (approximately 7
seconds), an audible signal will sound for 3 sec-
onds and the Green Ready Light will come back
on, indicating the product is ready to be served.
7. Carefully remove the steamed product.
STEAMING
CYCLE
START
READY
POWER
TM
Figure 6. Operating Controls
Yellow Steaming Light
Green Ready Light
Power Switch
Cycle Start Button
WARNING
Spatula out from unit. Be sure to allow steam
to escape before putting hands or face over the
steamer.
Hi-Limit Thermostat
A hi-limit thermostat will turn off electrical power to the
generator and Transformer circuits if the unit overheats.
Turn unit off and allow to cool; the hi-limit thermostat
will automatically reset when the unit cools down. If
the unit continues to shut off due to overheating,
contact your Roundup Authorized Service Agency.