Operating instructions

DELUXE FOOD WARMER
8
P/N 1010678 Rev. G 08/08
Unpacking
1. Remove unit and all packing materials from ship-
ping carton.
2. The unit should come with the items listed below:
 
 
 
250 only).
NOTE: If any parts are missing or damaged, con-
tact Antunes Technical Service IMMEDIATELY at
1-877-392-7854 or 1-630-784-1000.
3. Remove all packing materials and protective
coverings from the unit.
4. Remove and wash the Pan, Trivet, and Diffuser
(Figure 1) in soap and water. Rinse with clean
water and allow to air dry.
NOTE: The steam generator surface (Figure 9)
will have a white coating of artificial lime deposits.
This coating is necessary for steaming
characteristics.
5. Wipe all surfaces of the unit with a hot damp
cloth.
NOTE: Do NOT use a dripping wet cloth. Wring
out before use.
6. Re-install Pan, Trivet, and Pan Diffuser.
Equipment Setup
When placing the unit into service, pay attention to the
following guidelines:
  
at room temperature.
  
  
  
  
counter.
INSTALLATION
Figure 1. Components
Top Cover
Operating
Controls
Power Cord
Trivet
Pan
Pan Diffuser
Electrical
1. Place the unit on a sturdy, level table or other
work surface. Turn off the power before
proceeding.
2. Ensure that the line voltage corresponds to the
stated voltage on the units specification label and
power cord warning tag. If you are unsure of
your Line Voltage, contact your electrician.
3. Connect the unit to the power supply.
Figure 2. Warning Labels
THIS UNIT IS DESIGNED TO
OPERATE ON 120 VOLTS
ONLY. APPLICATION WITH ANY
OTHER VOLTAGE SUPPLY
COMPLETELY VOIDS ALL
WARRANTY. PLEASE CHECK
YOUR LINE VOLTAGE BEFORE
INSERTING THIS PLUG INTO THE
RECEPTACLE.
WARNING WARNING
120 VAC
ONLY
THIS APPLIANCE MUST BE
EARTHED (GROUNDED)
THIS APPLIANCE MUST BE
EARTHED (GROUNDED)
THIS UNIT IS DESIGNED TO
OPERATE ON 220-240 VOLTS
ONLY. APPLICATION WITH ANY
OTHER VOLTAGE SUPPLY
COMPLETELY VOIDS ALL
WARRANTY. PLEASE CHECK
YOUR LINE VOLTAGE BEFORE
INSERTING THIS PLUG INTO THE
RECEPTACLE.
WARNING WARNING
220-240
VAC ONLY
THIS APPLIANCE MUST BE
EARTHED (GROUNDED)
THIS APPLIANCE MUST BE
EARTHED (GROUNDED)