Operating instructions

DELUXE FOOD WARMER
16
P/N 1010678 Rev. G 08/08
CAUTION
Do not bend the Spray Tube. The tube is made of
Teflon® and any bends in the tube will result in
permanent damage.
5. Use a scraper or spatula to remove the excessive
calcium/mineral buildup from the Generator
surface (Figure 10).
6. Thoroughly wipe the Generator with a damp cloth
to remove any loose buildup and reassemble the
unit.
NOTE: If deposits are still excessive and/or difficult
to remove, refer to Steps 1 through 6 below
1. Pour delimer solution (not supplied) onto the
Generator surface. Follow the delimer manufac-
turer’s instructions for proper mixture and use.
Figure 10. Deluxe Food Warmer Components
(DFW-150 Shown)
Top Cover
Assy.
Hinge Pin
Diffuser
Steam
Generator
Surface
Spray
Tube
Assy.
Pan
Trivet
Gasket
MAINTENANCE (continued)
CAUTION
If a chemical cleaner is used, be sure it is safe to
use on cast aluminum. Observe all precautions
and warnings on the product label.
2. Using a sponge or a dry towel, remove the
delimer solution from the Generator surface and
then rinse the surface with clean water.
Cleaning Spray Tube and Steam Generator
1. Turn the power off, unplug the power cord, and
allow the unit to cool down before proceeding.
2. Perform the Daily Cleaning, but do NOT
reassemble the unit.
3. Remove the Spray Tube (Figure 9) by lifting the
loose end and pulling it out of the generator hole.
4. Slide the metal cover off of the Spray Tube, take a
paper clip and poke out all of the tube’s holes.
5. Gently wash the tube under running water to clear
the deposits out of the loose end. Reattach the
cover onto the tube.
Monthly Maintenance
The Deluxe Food Warmer utilizes an open Steam
Generator. Water sprayed onto the Generator surface
flashes into steam immediately, but the minerals in the
water do not steam. They stay on the Generator sur-
face. A small amount of calcium/mineral deposits are
needed for proper operation, but a buildup of excessive
calcium/mineral deposits causes poor steaming efficiency
and excessive moisture (wet steam), which will eventually
severely retard the steaming action completely.
NOTE: To ensure proper steaming characteristics,
some calcium/mineral deposits must be present on
the Generator surface. If, during cleaning, the sur-
face does become free of calcium/mineral deposits,
add plain tap water to the surface and allow it to
boil off. If necessary, repeat this process to formu-
late a thin coating of calcium/mineral deposits.
NOTE: In soft water areas. it may be necessary to
add a small amount of lime to the Generator surface
to season it. This will ensure proper steaming char-
acteristics by producing a thin coating of calcium/
mineral deposits on the Generator surface.
Seasoning mixture consists of 3/4 ounces (25 ml/
25 cc) baking soda, 3/4 ounces (25 ml/25 cc) lime
mixed with 1 quart (950 ml/950 cc) of water. Stir
mixture and pour 1/4” deep onto the hot Generator
surface. After mixture is converted to steam, the
remaining loose powder can be removed.
3. Plug the power cord into the appropriate outlet.
4. Turn the power on and allow the unit to warm up
for approximately 30 minutes.
5. Push and release the OPERATE button several
times to purge any remaining delimer residue from
the Generator surface.
6. Turn the power off, reinstall all parts and
accessories, and return the unit to service.