Operating instructions
DELUXE FOOD WARMER
15
P/N 1010678 Rev. G 08/08
OPERATION (continued)
Fault Codes
Seconds/SHO/H2O have been inadvertently changed
to a setting below or above their limits, the unit displays
the “ERR” fault code. If this code appears, you must
clear these settings using the following procedure:
1. Turn the power off.
2. Press and hold the PROGRAM and the
START/STOP buttons simultaneously.
3. Turn the unit on while holding the buttons.
Release the buttons when the unit stops beeping.
NOTE: Repeat Steps 1 through 4 if the unit still
displays the “ERR” fault code.
4. The display will now register 15:00.
NOTE: It is recommended that the SHO and H2O
settings be adjusted to the recommended settings
shown in the Programming section of this manual.
MAINTENANCE
WARNING
Turn the power off, unplug the power cord, and
allow the unit to cool down before performing any
service or maintenance.
CAUTION
Do NOT use a sanitizing solution or abrasive
materials. The use of these may cause damage to
the stainless steel finish.
CAUTION
If a chemical cleaner is used, be sure it is safe to
use on cast aluminum. Observe all precautions
and warnings on product label.
WARNING
Be sure to follow all of the precautions, proce-
dures, and safety steps listed in the Important
Safety Information section of this manual.
NOTE: Frequency of cleaning is determined by
water conditions, usage and water filter systems.
Daily Maintenance
1. Turn the power off, unplug the power cord, and
allow the unit to cool down before proceeding.
2. Check the Water Pressure Regulator gauge
(DFW/DFWT/DFWF-200/250 units only) and
verify that it reads 20–25 psi (1.4–1.7 kg/cm
2
or
138–172 kPa). If not, adjust the water pressure
as described in the Installation section of this
manual. Check the rear water Quick Disconnect
Fitting and Hose Clamp for leakage. Tighten
clamps or replace parts if needed.
3. Remove the Trivet and Pan (Figure 10).
4. Wash items in hot, soapy water and then rinse
and WIPE DRY.
5. Wipe down the Top Cover, Gasket, and the entire
exterior of the unit (Figure 10) with a clean, hot,
damp cloth (not dripping wet ) and wipe dry.
6. Re-install Diffuser, Pan and Trivet.
NOTE: Allow Top Cover to remain open overnight.
NOTE: Failure to properly clean and dry the above
mentioned items may result in the accumulation
of water/moisture overnight. This may lead to per-
manent damage to the equipment’s finish and its
accessories. This damage is not covered by war-
ranty.
READY
UP DOWN PROGRAM START/STOP
POWER
ERR
Figure 9. “ERR” Fault Code