Specifications

STS-200 STEAMER/SCALE
10
P/N 1010929 Rev. B 03/12
A.J. Antunes & Co.
MAINTENANCE (continued)
Weekly Maintenance
CAUTION
Observe all instructions, precautions, and warnings on
cleaning product labels.
IMPORTANT
Turn off the power, unplug the power cord, and allow
the unit to cool down before proceeding.
Daily Maintenance
IMPORTANT
Turn off the power, unplug the power cord, and allow
the unit to cool down before proceeding.
The STS-200 Steamer/Scale utilizes an open Steam
Generator. Water sprayed into the Steam Generator
surface flashes into steam immediately, but the miner-
als in the water do not steam. They stay on the Steam
Generator surface and accumulate. A small amount of
mineral deposits are needed for proper operation, but
a build-up of excessive mineral deposits causes poor
steaming efficiency, excessive moisture (wet steam)
and will eventually severely retard the steaming action
completely.
CLEANING STEAM GENERATOR
  
2. Remove the Top Cover from unit.
  
4. Clean Steam Generator free of any product spills.
NOTE: If the mineral deposits come off in flakes or
layers, build-up is excessive.
Figure 4. Dirty Steam Generator
Figure 5. Clean Steam Generator
CLEANING THE STEAMER SCALE
  
hose clamp connections for leakage. If leakage
is apparent, tighten all clamps or replace part if
required.
  
a solution of Steam Generator Cleaner (HCS).
3. Use a wire brush to clean/remove the meat residue

  
  Sanitizer
Solution (HCS) and then again with clear water.
Allow to air dry.
6. Clean the Steam Generator by wiping off any
meat and meat juices.
7. Pour some Steam Generator Cleaner (HCS) into
the Steam Generator. Wait 15 minutes and then
use the wire brush to clean the Steam Generator
by removing all meat and meat juices.
8. Rinse the Steam Generator with clear water.
9. Rinse the Steam Generator using Sanitizer
Solution (HCS) and then again with clear water.
Repeat this step as needed until the Steam
Generator is cleaned.
10. In this step, the cloths are to be damp, NOT
dripping wet. Clean the Steamer Scale base
using a damp soft cloth and General Detergent
Cleaner (HCS).
11. Rinse the Steamer Scale base with a soft cloth
dampened with clear water.
12. Rinse the Steamer Scale base using a soft cloth
dampened with Sanitizer Solution (HCS) and
then a soft cloth dampened with clear water.
  
power cord into the appropriate outlet.
14. Turn the Steamer/Scale on, allow the unit to
preheat for 30 minutes, and zero it by pressing Zero
(on) button on the front of the unit (Figure 3).
15. If the Water Inlet Tube becomes clogged so that
water cannot flow onto the Steam Generator, refer
to the Cleaning The Water Inlet Tube section in
this document.