Specifications

CCC-20 TECHNICAL MANUAL
LAST UPDATE 5-1-05
1060005 5/05
TESTING SAFETY INTERLOCK SWITCH
See Safety Interlock Switch under “Component Description & Function” before proceeding.
Disconnect wires to isolate switch.
Verify continuity across the switch with the plunger
manually depressed. Next, release plunger. Reading
should now be infinity.
Replace if fails test.
Replacement Procedures
Remove service panel.
Disconnect switch wires.
Remove the two mounting screws.
Install new switch along with the new o’ring & secure with screws.
NOTE: The o’ring must always be used. Failure to do so may result in
water/moisture damage to electrical components.
Reinstall wiring onto switch.
Test unit for proper operation.