Specifications

CCC-20 TECHNICAL MANUAL
LAST UPDATE 5-1-05
1060005 5/05
TESTING HEAD ASSEMBLY
See Head Assembly under “Component Description & Function” before proceeding.
If any of the head assembly’s electrical components are malfunctioning, each
component must be tested individually
TESTING POWER SWITCH
See Power Switch & Splash Guard under “Component Description & Function” before proceeding.
Disconnect wires to isolate switch.
Turn switch to the “On” position. Verify
continuity across terminals 1 & 2, then 4 & 5.
Next, turn switch to the “Off” position.
Reading should now be infinity.
Replace if fails test.
Replacement Procedures
Remove service panel.
Disconnect power switch wires (Mark for reinstallation).
Squeeze locking tabs inward & push switch & splash guard away from unit.
Install new switch along with the splash guard.
NOTE: If splash guard is damaged or missing, it must be replaced.
Failure to do so may result in water/moisture damage to electrical components.
Reinstall wiring onto switch.
Test unit for proper operation