MANUFACTURING NUMBERS: 9100480 9100482 9100483 9100486 MIRACLE STEAMER C L IS T ED US AN I T A T IO L IS Models MS-355 ERTEK INT N S T ED CM C L IS T ED US P/N 1010456 Rev.
MIRACLE STEAMER TABLE OF CONTENTS Owner Information......................................................2 General.......................................................................2 Warranty Information..................................................2 Service/Technical Assistance.....................................3 Model Designation......................................................3 Important Safety Information.....................................3 Specifications................................
MIRACLE STEAMER OWNER INFORMATION (continued) Service/Technical Assistance Use only genuine Roundup replacement parts in this unit. Use of replacement parts other than those supplied by the manufacturer will void the warranty. Your Authorized Service Agency has been factory trained and has a complete supply of parts for this unit. If you experience any problems with the installation or operation of your unit, contact your Authorized Service Agency.
MIRACLE STEAMER IMPORTANT SAFETY INFORMATION (continued) In addition to the warnings and cautions in this manual, use the following guidelines to safely operate the unit. • Read all instructions before using equipment. • For your safety, the equipment is furnished with a properly grounded cord connector. Do NOT attempt to defeat the grounded connector. • Install or locate the equipment only for its intended use as described in this manual. Do NOT use corrosive chemicals in this equipment.
MIRACLE STEAMER SPECIFICATIONS Electrical Ratings Electrical Cord & Plug Configurations Model and Mfg. No. Voltage Watts Amps Hertz Model and Mfg. No. Description MS-355 9100480 208 3300 15.9 50/60 MS-355 9100482 120 1800 15.0 50/60 MS-355CV 9100480 9100486 MS-355 9100483 120 1800 15.0 50/60 6-20P, 20 Amp., 250 VAC., Non–locking (Assembly Only). MS-355CV 9100486 230 MS-355CF 9100482 5-15P, 15 Amp., 120 VAC., Non-locking (Assembly Only). 3300 14.
MIRACLE STEAMER INSTALLATION Unpacking Drawer 1. Remove the unit and all packing materials from the shipping carton. 2. The unit should come with the items listed below: • Owner’s Manual • Authorized Service Agency Directory • Drawer Assembly Drip Pan NOTE: If any parts are missing or damaged, contact A.J. Antunes IMMEDIATELY at 1-800-253-2991 or 1-630-784-1000. Drawer Liner with Rollers 3. Remove all packing materials and protective coverings from the unit. Figure 1. Washing Parts 4.
MIRACLE STEAMER INSTALLATION (continued) WARNING THIS APPLIANCE MUST BE EARTHED (GROUNDED) 120 VAC ONLY WARNING THIS APPLIANCE MUST BE EARTHED (GROUNDED) 208 VAC ONLY WARNING THIS APPLIANCE MUST BE EARTHED (GROUNDED) 220-240 VAC ONLY WARNING Electrical THIS APPLIANCE MUST BE EARTHED (GROUNDED) 1. Set the unit on a sturdy, level table or work surface. THIS UNIT IS DESIGNED TO OPERATE ON 120 VOLTS ONLY. APPLICATION WITH ANY OTHER VOLTAGE SUPPLY COMPLETELY VOIDS ALL WARRANTY.
MIRACLE STEAMER OPERATION Programming Ready Light CYC (Total Cycle Time) refers to the total programmed steam time set for the product. READY SINGLE SHOT UP DOWN PRGM START/STOP Message Display SHO (Shot Interval Time) is the time set between shots of steam during a complete cycle. Start/Stop Button H2O (Steam Shot Time) refers to the water volume used by the water pump or solenoid valve.
MIRACLE STEAMER OPERATION (continued) 6. Press and release and then press ▲ or ▼ to change the SHO in seconds (Figure 4, Item E). READY READY 7. Press and release again and press ▲ or ▼ to change the SHO in minutes (Figure 4, Item F). 15 1500 SINGLE SHOT SINGLE SHOT UP DOWN PRGM START/STOP A. Total Cycle Time READY UP DOWN PRGM B. Total Cycle Minutes SHO SINGLE SHOT SINGLE SHOT DOWN PRGM START/STOP C.
MIRACLE STEAMER OPERATION (continued) Hi-Limit Reset Button Cap Hi-Limit Reset Button A hi-limit thermostat turns off electrical power to the steam generator if it overheats. To reset this thermostat, allow approximately 45 minutes for the unit to cool down, remove the black cap, and then press the black reset button located on the rear of the unit (Figure 5). If the unit requires continuous resetting, contact your Authorized Service Agency.
MIRACLE STEAMER MAINTENANCE Daily WARNING Turn the power off, unplug the power cord, and allow the unit to cool down before performing any service or maintenance. 1. Turn the power off, unplug the power cord, and allow the unit to cool down before proceeding. 3. Remove the Drawer, Drawer Liner with Rollers, Drip Pan, Top Cover, and Steam Vent (Figure 7).
MIRACLE STEAMER MAINTENANCE (continued) Monthly The Miracle Steamer utilizes an open steam generator. Water sprayed onto the Generator surface flashes into steam immediately, but the minerals in the water do not steam, they stay on the Generator surface. A small amount of calcium/mineral deposits are needed for proper operation, but a buildup of excessive calcium/ mineral deposits causes poor steaming efficiency, excessive moisture (wet steam) and will eventually severely hinder the steaming action.
MIRACLE STEAMER TROUBLESHOOTING WARNING To avoid possible personal injury and/or damage to the unit, inspection, test and repair of electrical equipment should be performed by qualified service personnel. The unit should be unplugged when servicing, except when electrical tests are required. Problem Control Display is blank (power is on but indicator light is off). Control Display is blank (power is on and indicator light is on). Possible Cause The power cord is not correctly plugged in.
MIRACLE STEAMER TROUBLESHOOTING (continued) Problem Unit heats but there is little or no steam produced and/or The product requires more steaming than usual. Possible Cause Corrective Action Filter Strainer is restricted. Check and clean the Filter Strainer as described in the Maintenance section of this manual. Unit is not being cleaned properly (daily/monthly). Clean unit daily and monthly as described in the Maintenance section of this manual.
MIRACLE STEAMER REPLACEMENT PARTS 53 27 26 2 46 46 19 10 74 75 77 73 76 46 11 1 25 A WADD TE R 30 13 70 71 18 RE AD Y 52 56 16 8 69 65 7 61 9 55 4 64 66 67 82 6 68 3 72 65 69 P/N 1010456 Rev. C 08/12 15 A.J. Antunes & Co.
MIRACLE STEAMER REPLACEMENT PARTS (continued) AD WATD ER REA DY 79 51 38 51 54 38 AD WA D TE R 34 63 41 40 59 78 23 17 40 33 41 78 35 37 39 20 83 36 29 81 47 43 57 42 15 47 14 45 58 44 62 50 12 51 22 REA DY 60 47 49 32 28 49 48 16 A.J. Antunes & Co. P/N 1010456 Rev.
MIRACLE STEAMER REPLACEMENT PARTS (continued) Item Part No. 1 2 3 4 6 7 8 9 10 11 Description 0011314 7000237 0011413 0011471 040P138 040K251 0503441 0503536 0503712 0700452 Steam Vent Assy. Top Cover Assy. (Incl. #73-77) Liner Assy. (Incl. #65, 69, 72) Drawer Assy. (Incl. #64-71) Locknut, Conduit, 1/2” Strain Relief (includes #6) Cover, Access Drip Pan, Water Cover, Tank Housing Power Cord, NEMA 6-20P 250v Mfg. No. 9100480 & 486 0700463 Power Cord, 5-15P 120V Mfg. No. 9100482 0700451 NEMA 5-20P 20 Amp.
MIRACLE STEAMER WIRING DIAGRAMS *NOTE: For 208-240 VAC units, the two primary coils are wired in series with one another. For 120 VAC units, the two primary coils are wired in parallel with one another. 18 A.J. Antunes & Co. P/N 1010456 Rev.
MIRACLE STEAMER NOTES P/N 1010456 Rev. C 08/12 19 A.J. Antunes & Co.
LIMITED WARRANTY Equipment manufactured by Roundup Food Equipment Division of A.J. Antunes & Co. has been constructed of the finest materials available and manufactured to high quality standards. These units are warranted to be free from electrical and mechanical defects for a period of one (1) year from date of purchase under normal use and service, and when installed in accordance with manufacturer’s recommendations.
