Owner`s manual

P/N 1010455 Rev. E 01/15 5
INSTALLATION
Unpacking
1. Remove the unit and all packing
materials from the shipping carton.
2. The unit should come with the items
listed below:
• Owner’s Manual
• Authorized Service Agency
Directory
• Inlet Hose Assembly
• Spatula Assembly (MS-250 only)
• Drawer Assembly (MS-255 only)
NOTE: If any parts are missing or
damaged, contact A.J. Antunes
IMMEDIATELY at 1-800-253-2991
or 1-630-784-1000.
3. Remove all packing materials and
protective
coverings from the unit.
4. MS-250: Remove and wash the Wire
Trivet, Spatula, Spatula Liner, and
Drip Pan (Figure 1) in soap and water.
Rinse with clean hot water and allow
to air dry.
5. MS-255: Remove and wash the
Drawer, Drawer Liner with Rollers,
and Drip Pan (Figure 2) in soap and
water. Rinse with clean hot water
and allow to air dry.
6. Wipe all surfaces of the unit with a
hot, damp cloth.
NOTE: Do NOT use a dripping wet cloth.
Wring out before use.
7. MS-250 Models: Assemble the
Guard and Mounting Bolt to the
Spatula (Figure 3). Then install the
Wire Trivet into the side slots on the
Spatula.
8. Re-install all removed parts.
Equipment Setup
When placing the unit into service, pay at-
tention to the following guidelines:
y Make sure power is o and the
unit is at room temperature.
y Do NOT block or cover any
openings on the unit.
y Do NOT immerse cord
or plug in water.
y Keep cord away from heated surfaces.
y Do NOT allow cord to hang over
edge of table or counter.
Figure 3. Assembling Handle–MS-250 Only
Bolt
Handle
Spatula
Handle Guard
Wire Trivet
Figure 2. Washing Parts–MS-255 Only
Spatula
Wire Trivet
Spatula Liner
Drip Pan
Figure 1. Washing Parts–MS-250 Only
Drawer
Drip Pan
Drawer Liner
with Rollers