Owner`s manual

P/N 1010455 Rev. E 01/15 11
Figure 12. Inlet Hose Assembly
MALE QUICK
DISCONNECT INSERT
STRAINER CUP
TUBING
Checking and Cleaning the Water Strainer
The Water Strainer protects your equipment
from any foreign debris in the water line
that could get into the food or damage the
unit’s solenoid and cause the unit to leak
or ood. It also protects the equipment’s
proper and consistent operation from
interference.
To ensure proper and consistent steaming
results, check the Water Pressure Regulator
and Strainer Cup regularly. If the pres-
sure has dropped, check the Strainer Cup
and clean out the accumulated debris as
follows.
1. Shut o the water supply valve to
the unit, unscrew the clear, plastic
Strainer Cup and carefully remove
the Mesh Screen.
2. At the sink, gently ush all of the ac-
cumulated debris from the Strainer
Cup and Mesh Screen. Be especially
careful not to damage the Mesh
Screen.
3. Carefully place the Mesh Screen into
its seat at the bottom of the Strainer
Cup and conrm that the orange
O-ring is properly seated in its place
before screwing the Strainer Cup
and top back together.
4. Purge the air out of the strainer and
tubing by disconnecting the Male
Quick Disconnect Insert from the
equipment and, over a bucket, push
the white plastic tip in until there is
good water ow.
5. Replace damaged or worn parts as
needed.
6. Verify that the Water Pressure
Regulator is set to 20–25 psi (1.4–1.7
kg/cm
2
or 138–172 kPa).
MESH
SCREEN
O-RING