Operating instructions
MIRACLE STEAMER
13
P/N 1010699 Rev. C
A.J. Antunes & Co.
• liner • steam vent
• generator cover • diffuser
10. Clean steam chamber of any product spills.
11. Clean unit surface with a hot, clean, damp
cloth (not dripping wet) and wipe dry.
12. Re-install all parts and fasten the generator
cover.
NOTE: To ensure proper steaming characteristics,
some mineral deposits must be present on genera-
tor casting. If during cleaning, the casting does
become free of mineral deposits, add plain tap
water to casting and allow to boil off.
NOTE: In soft water areas, it may be necessary to
add a small amount of lime to generator to “sea-
son” it. This will ensure proper steaming character-
istics by producing a thin coating of mineral depos-
its on the casting.
Seasoning mixture consists of 2 ounces (59.15
milliliters) baking soda, 2 ounces (59.15 milliliters)
lime mixed with 2 ounces (59.15 milliliters) of warm
tap water.
Figure 8. Miracle Steamer Components
R
E
A
D
Y
Spatula (MS-150/250 only)
Liner (MS-150/250 only)
Drip Pan (MS-155/255/355 only)
Liner (MS-155/255/355 only)
Drawer (MS-155/255/355 only)
Top Cover
Wingnut
Cover
Diffuser
Steam Vent
MS-355 Shown
4.
Remove the diffuser.
5.
Examine all generator orifices (holes). If mineral
deposits have formed, place a flat blade screw
-
driver into openings. Use a gentle twisting motion
to scrape openings clean.
NOTE: If the mineral deposits come off in “flakes”
or in layers, build-up is excessive.
6.
Use a brass or stainless steel wire brush to
remove deposits from the generator surface.
7. Pour a delimer solution (not supplied) onto the
generator surface and allow to soak for one hour.
Be sure to follow the delimer manufacturer’s
directions for proper mixture and use.
NOTE: Use only a Aluminium safe de-liming prod
-
uct.
8. Remove the delimer solution from the gen
-
erator and rinse with clear water to remove
traces of delimer.
9.
Clean the following parts in hot detergent
water, then rinse in clear water and allow to
air dry:
•
spatula/drawer
• top cover