Specifications

MS TECHNICAL MANUAL
LAST UPDATE 12-10-04
1060003 12/04
REPLACING WATER PUMP
Water Tank Equipped Models
See Water Pump under “Component Description & Function” before proceeding
Replacement procedures
Turn power off & unplug unit.
Drain the water tank.
Disconnect pump wires.
Remove rubber hoses, bottom mounting nuts, & pump.
Install new pump assembly & secure with the nuts.
NOTE: Arrow on pump body should correspond with water flow
Reinstall rubber hoses & wiring.
Verify the water tank filter is properly installed & not torn. Replace if needed.
NOTE: MS-355 does not contain a water filter.
Fill tank with water & test unit for proper operation.