Specifications

MS TECHNICAL MANUAL
LAST UPDATE 12-10-04
1060003 12/04
TROUBLE SHOOTING
Problem Possible Cause Corrective Action
The power cord is not correctly plugged in. Plug the power cord into the appropriate
outlet.
The power cord and/or electrical plug is
damaged.
Inspect electrical wire, plug, and receptacle.
The main electrical panel circuit breaker is off
or has been tripped.
Reset circuit breaker. See parts testing and
replacement section of this manual
Switch is inoperable. See parts testing and
replacement section of this manual
Control Board is inoperable
Transformer is inoperable.
Loose, burnt, or broken wires in cir-cuit.
Hi-Limit Thermostat is tripped or inoperable.
Solid State Relay is inoperable.
Thermocouple is inoperable.
Control Board is inoperable.
Steam Generator is inoperable.
Loose, burnt, or broken wires in cir-cuit.
The unit’s main electrical panel cir-cuit breaker
trips.
Damaged receptacle, plug, or cord; a loose
connection or an internal component failure.
Turn the unit off, allow it to cool to room
temperature, and then restart the unit.
See parts testing and
replacement section of this manual
Reset the Hi-Limit Thermostat according to the
Operations sec-tion of this manual. If the
Hi-Limit Thermostat requires continuous
resetting, See parts testing and
replacement section of this manual
““““
““““
““““
““““
““““
Unit does not heat up (Control Display is on)
See parts testing and
replacement section of this manual
““““
““““
Control Display is blank (power On/Off switch
is on and indicator light is on).
Control Display is Blank (power On/Off
switch is On but indicator light is off).