Specifications
MIRACLE STEAMER
12
P/N 1010881 06/04
MIRACLE STEAMER
13
P/N 1010881 06/04
steamer. This purges any remaining delimer
residue from the generator surface.
10. Turn the unit off, reinstall all parts and accesso-
ries, and return the unit to service.
MS-150 WATER TANK FILTER
The Water Tank Filter is used to prevent solids or food
products from entering and damaging the water pump.
The unit uses a water filter (Figure 9). Inspect and
clean this filter monthly or more regularly using the fol-
lowing procedure:
NOTE: The water level should be very low or near
empty.
1. Turn the Rocker Switch (power On/Off) to OFF.
Unplug the power cord and allow the unit to cool
down before proceeding.
2. Open the Slide Door (Figure 9).
3. Remove the filter, located inside the tank, by pull-
ing it upwards and out of the bottom hole.
4. Clean the Filter by running it under tap water.
Replace the Filter if the screen is torn or dam-
aged.
5. Reinstall the filter stem into the bottom hole of the
tank (Figure 9).
6. Fill the Water Tank and test the unit.
4. With the unit cool, use a wire brush and/or scrap-
er to loosen and remove the excessive calcium/
mineral deposits from the generator surface
(Figure 8). Next, take a wire brush and clean
out any build up that has accumulated in the 28
steam ports (26 vertical and 2 horizontal) of the
generator (Figure 8). Remove the loose build up,
wipe the generator with a clean, damp cloth, and
reassemble the unit.
NOTE: If deposits are still excessive and/or diffi-
cult to remove, refer to Steps 5 and 10.
5. Pour delimer solution (not supplied) onto the gen-
erator surface. Follow the delimer manufacturer’s
instructions for proper mixture and use.
6. Using a sponge or a dry towel, remove the
delimer solution from the generator surface, then
rinse with clean water.
NOTE: To ensure proper steaming characteristics,
some calcium/mineral deposits must be present on
the generator surface. If, during cleaning, the sur-
face does become free of calcium/mineral deposits,
add plain tap water to the surface and allow it to
boil off. If necessary, repeat this process to formu-
late a thin coating of calcium/mineral deposits.
CAUTION
If a chemical cleaner/delimer is used, be sure it is
safe to use on cast aluminum. Observe all pre-
cautions and warnings on the product label.
NOTE: In soft water areas, it may be necessary
to add a small amount of lime to the generator to
“season” it. This will ensure proper steaming char-
acteristics by producing a thin coating of calcium/
mineral deposits on the generator surface.
Seasoning mixture consists of 3/4 ounces (25ml/
25cc) baking soda, 3/4 ounces (25ml/25cc) lime
mixed with 1 quart (950ml/950cc) of water. Stir
mixture and pour 1/4” deep onto the hot generator
surface. After mixture is converted to steam, the
remaining loose power can be removed.
7. Plug the power cord into the appropriate outlet.
8. Turn the Rocker Switch (power On/Off) to ON.
Allow the unit to warm up for approximately 30
minutes.
9. Push and release the Operate button or the
Single Shot button several times to operate the
MAINTENANCE (continued)
Figure 8. Water Tank Filter
Water Tank Filter
Filter Stem
Access
Cover
with Tank
(dotted line)
Bottom
Hole
of Water
Tank
Slide Door